4 Replacement Procedures
Satellite A80 Series Maintenance Manual 4-31
4.15 Speakers
Removing the Speakers
To remove the speakers, first remove the top cover, then follow the steps below:
Figure 4-28 Removing the speakers
1. Remove two black M2.5x3 screws securing each speaker into place.
2. Lift out the speakers.
Installing the Speakers
To install the speakers, follow the steps below and refer to the figure in the preceding section:
1. Seat each speaker. The speaker cases are marked with L (left) and R (right).
2. Secure each speaker with two black M2.5x3 screws.
3. Attached the left and right speaker cables to the system board.
To Next Page
Loading...
