User’s Manual 7-3
HW Setup and Passwords
3. Click the OK button. If the character string you enter matches the reg-
istered password, the password option is reset and the display
changes to:
Not registered
If they do not match, the following message appears. You must repeat
step 1.
Incorrect Password.
4. Follow the same procedures described in the earlier section, How to
set the password, to set a new user password.
Display
This tab allows you to customize your computer’s display settings for either
the internal LCD screen or for an external monitor.
Power On Display
Allows you to set the display to be used when the computer is booted.
If you enter the password incorrectly three times in a row, the computer
need to shut off.
You will not be able to access the password option in the HW Setup. In this
case you must turn the power off and back on to retry the procedure.
Auto-Selected Selects an external monitor if one is connected,
otherwise, it selects the internal LCD display
(Default).
System LCD only Selects the internal LCD, even if an external
monitor is connected.
To Next Page
Loading...
