User’s Manual 7-5
HW Setup and Passwords
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in sleep mode, you can
turn on the computer by pressing any key. It is effective only for the internal
keyboard and only when the computer is in sleep mode.
USB
Legacy USB Support
Use this option to enable or disable USB Legacy Emulation. If your
operating system does not support USB, you can still use a USB mouse
and keyboard by setting the USB Legacy Emulation item to enabled.
LAN
Wake-up on LAN
This feature lets the computer’s power be turned on from shutdown when it
receives a wake-up packet (Magic packet) from the LAN.
Regarding Wake-up on LAN from sleep or hibernation, you must check the
“Allow the device to wake the computer” check box within the LAN Device
properties”(This feafure does not effect the Wake-up on LAN from sleep or
hibernation).
■ If a supervisor password is set, the menu above does not appear when
you use the user password to start the computer.
■ The selection method above does not change the boot priority settings
in HW Setup.
■ If you press a key other than one of those above or if the selected
device is not installed, the system will boot according to the current
setting in HW Setup.
Enabled Enables the Wake-up on Keyboard.
Disabled Disables the Wake-up on Keyboard. (Default)
Enabled Enables the USB Legacy Emulation. (Default)
Disabled Disables the USB Legacy Emulation.
Enabled Enables the Wake-up on LAN from shotdown.
Disabled Disables the Wake-up on LAN from shotdown.
(Default)
To Next Page
Loading...
