12
CALL butLun [_
DISPLAY button
Number butlons [_
PROGRESS VE button [_
COUNTER RESET b_JttonI
ANGLE button [_
SP/SLP button [_ __
PLAY MODE button [_
REC button [_ m _ A B RPT button [_
OTR button[_ INDEX button [_
SKIP I_.l button [_)
[A>
(vcm
(DVD> [_
_ ATR butLun [_
SUBTITLE buttu_,
AUDIO SELECT butLun
INDEX + buiton [_
* MENU button
Use the MENU button to display the menu included ol/
many DVD video discs To operate a menu¸ _,ow tile
instructions in 'DVD Menu =[]_
_btennct eonnedions
If you are _,sing an antenna systeF follow these nst _,ctions If you are a cabe (CATV) subsc ber skip ahead to page 16
for the proper con_ections
The DVD,VCR must be connected _between the antenna and the TV First disconnect the antenna from the TV and
connect t to the DVD VCR Then connect the DVD,VCR to the TV Bebw are 3 common methods of connecting an antenna
system to a DVD'VCR Fnd the type of antenna system you are using and follow the connect on diagram
Combination VHF/UHF Antenna with 75 ohm Coaxial Cable DVDNCR
_I_,0 _-_
Combination VHF/UHF Antenna with 300 ohm Twin Lead (Fiat) Wire DVD _,/CR
3
[ !lmerting Batteries
S!ide the barrel? compartmentcover in the d rect on of the
artov_
install two AAA' batteries
(supplied} paying attention to the
polarity diagram in the battery
compadment
Battery precautions
The precautions below should be fullowed when using battelies in this device
/ Use only the size and type _ batteries specified
2 Be sure to _llow the con ed polarity when instal!ing the batteries as indicated in the bat_ry compa_ment Re
vel_ed batteries may cause damage to the device To avoid a p_ential short circuit insefl the end firs1
3 Do n_ mix diffel_nt types _ batteries togethe_ (e g Alkaline and Carbon zinc} or old bat_ries wi_h fresh ones
4 If the device is not _ be used _r a long period of time, relqove the batlelies _ p_vent damage or iniury f_m
possible bat_ leakage
5 Do not tl_/_ recha_e bat_ries _ol intended _ be _cha_ed; they can overheat and _ptu_ (Follow battery
manu_ctu_ s directions }
• Press POWER (I/Lb) to turn the DVD VCR on or off
• Select yore desiled operating mode (DVD or VCR) using VCR DVD
(DVD or VCR indicator on the flont pane! wiU show you which mode is seleded )
• Press CN + or CH 1o move thro[ gh the channels one channel at a time
• The C H +M ( • / • } and SET +/- (• / _) al_ also [sed to navigate on screen menu system
• You can d rectty access specific channels using Number buttons
• Each press of VCR DVD on the _emote contlol, swMles the screen be wean the VCR screen (VCR mode} and the
DVD screen (DVD mode}
Operation
• Aim the remote control at the _emote sensor and press cont191 britons to
operate
• Operate the remote control within 30 angle on either side of the i_mote
senso£ up to a distance of App_ox 7 meters App_ox 7 meters
After you have connected the antenna to the DVD,VCR you must conned the DVDIVCR tu the TV
Below ale 3 con- mort methods of com/ectmg ymr DVDiVCR to a T_ Rnd tile type ofTV you are using and fo,ow the
connect on diagram
This DVD,VCR has a single 75 ohm output tel connection to a 7V If your TV has separate VHF and UHF antenna
npds (numbers 2 and 3 below), [se a spl tte_ to connect the DVD VCR to the TV for VHF and UHF reception
300 ohm Twin Lead (Fla_) Wre
(not supp led)
Separate VHF and UHF Antennas DVD _'/CR
| 3OOohm Twin Lead (Flat) W_re II
i i (.......... ) _ =ullllllllllll_" (D m) 0 I |
,: :'"'_, _l_r- o_ II
75 ohm Coaxial Cable I I
If both VHF and UH Fartennas have 300 ohm t_ei_lead (flat) wire_ use a combiner having two 300 ohm input_ and
or>e 75 ohm output
Notes:. A clear piciufe wll not be obtained by the DVDNCR unless the antenna _ignal is good Connect the antenna to
the DVD/VCR properly
• For better quality recordin_ an indoor antenna or a telescopic a_tenna is not recommended The use of an outdoor type
antenna is required
14 • if you are not sure about the con_ect_on please refe_ to qualified semite person_el
75 ohm Coaxial Cable (supplied)
TV
Note: If a VHF or UHF antenna is used,
set the TV/CATV menu option to
the 'TV" mode.
,_,/with single 75 ohm VHPUHF antenna
input
TV
Note: If a VHF or UHF antenna is use&
Splitter 75 ohm Input set the TV/CATV menu option to
751300 ohf _ o_ltputs the "TV '_ mode.
75 ohm Coaxial Cable no supp ed)
(supplied}
_ TV with 300 ohm UHF ard 75 ohm VHF
ar;tenna inputs
TV
Note: If a VHF or UHF antenna is use&
set the TV/CATV menu option to
Spl tter 75 ohF Input the 'TV" mo_e
300 ohm outputs
75 ohm Coaxial Cable <not _upplied)
(_upplied) @ _ TV with 300 ohm UHF and 300 ohlrl VHF
antenna i_put_
131
151
To Next Page
Loading...
