Toshiba SD-V393SU2 - Preparation for Servicing; Servicing Fixtures and Tools

SERVICING FIXTURES AND TOOLS
Taper nut driver
70909228
Back tension cassette gauge
70909103
Torque cassette gauge
(KT-300NR)
70909199
Adapter
Dial Torque Gauge
(10~90gf•cm)
(60~600gf•cm)
JG154 Cable
VTR cleaning kit VTR lubrication kit Grease JG002B
JG002E
JG002F
JG153 X Value Adjustment
Screwdriver
JG022 Master Plane JG024A Reel Disk Height
Adjustment Jig
Alignment Tape
ST-N5
ST-NF
JG185 TentelometerJG176 Up-Date Disc
Remarks
Part No.Ref. No. Parts Name
JG002B
JG002E
JG002F
APJG002B00
APJG002E00
APJG002F00
Adapter
Dial Torque Gauge (10~90gf•cm)
Dial Torque Gauge (60~600gf•cm)
VSR Torque, Brake Torque (S Reel/T Reel Ass'y)
Brake Torque (T Reel Ass'y)
VSR Torque, Brake Torque (S Reel)
JG154 APJG154000 Cable Used to connect the test point of SERVICE and GROUND
APJG022000JG022 Master Plane Reel Disk Height Adjustment
JG024A APJG024A00 Reel Disk Height Adjustment Jig Reel Disk Height Adjustment
JG153 APJG153000 X Value Adjustment Screwdriver X Value Adjustment
JG176 APJG176084 Up-Date Disc Up-Date of the Firmware
D1-1
JG185 APJG185000 Tentelometer Confirmation of Tape Tension on Playback
PREPARATION FOR SERVICING
1.
2.
3.
How to use the Servicing Fixture
While pressing the CH DOWN button on the set for more than 2 seconds, press the ON/STANDBY button on the set
simultaneously at the Power OFF. Although the DVD is connected, the DVD mode cannot be selected.
Short circuit between TP3001 and Ground with the cable JG154.
(The BOT, EOT, and the Reel Sensor do not work and the VCR deck can be operated without a cassette tape.)
In case of using a cassette tape, press the STOP/EJECT button to insert or eject a cassette tape.
Turn on the power and re-check the cable before checking the trouble points.
When you servicing with connection of DVD, perform the operations above step 2 to step 3.