Toshiba Strata VI - Telephone Number Storage IO-I I

TOSHIBA
:
TELEPHONE NUMBER (continued)
STORAGE
Q Remove the handset from its hook (do not ac-
tivate a [col or llNTl line)
c Dial the q and q keys, respectively.
0 Dial a Z-digit address code. Codes run
consecutively from GO through 83 (GO
through 99 if optional card is installed).
0 Dial the telephone number to be stored.
after the trunk access code to allow for dial tone delay.
Press the -1 key after entering the PBX access code.
@ Dial the fl key to record the number in memory.
@ Repeat the above steps with every number (up to
the standard 24) to be stored.
0 Return the handset to on-hook.
@ Write down the address codes and telephone
numbers for future reference.
Repeat this procedure to replace the stored telephone
numbers with new telephone numbers.
TO STORE A TELEPHONE NUMBER IN STATION
MEMORY (Optional Feature)
Telephone numbers can 6e stored by each station.
0 Lift the handset (do not activate a B or @I
line).
@ Dial the q and q keys, respectively.
@ Dial a Z-digit address code (codes run con-
secutively from 10 through 49).
@ Dial the telephone number to be stored.
BEHIND PBX: It is necessary to insert a pause
after the trunk access code to a/low for dial
tine delay. Press the -1 key after
entering the PBX access code.
a Dial the H key to record the number in memory.
’ Repeat the above steps with every number to be
stored (up to 40).
f, Return the handset to on-hook.
0 Write down the address codes and telephone.
numbers for future reference.
Repeat this procedure to replace the stored telephone
numbers with new ones.