Toshiba Strata VI - Intercom Calls; Call Holding

TO MARE AN INTERCOM CALL
0 Lift the handset.
0 Depress an available m key, and you
will hear a continuous INT dial tone.
c The INT LED will flash at a steady-
double flash rate ( ’ ‘I’ ‘-use).
= Dial the desired extension number, and
you will hear a single ring tone.
5 Speak when the ring tone ends.
0 Hang up when the call is completed.
Tone signaling can be accompLished by
dialing /YJ after the extension number. An
intercom caZl may be answered at any
station.
TO RECEIVE AN INTERCOM CALL
0 You will hear a single long tone, followed
by the caller’s voice.
0 The INT LED will flash at a medium pulsating
on/off rate (“I”-called).
0 Lift the handset.
0 The INT LED will flash at a steady-double flash
rate (“I”-use).
Q Hang up when the call is completed.
CALL HOLDING
TO HOLD A CALL
0 While connected to an outside call, depress
the j-1 key.
0 The CO line LED will flash at a fast rate
(“I”-hold).
On-hoM reminder tone will be heard within a
pre-determined time.
Hol’d will be automaticab’y
released if the other party hangs up. When a CO
line is placed on hold it may be picked up at any
station.