Upgade the software
Connect the control cable to the control terminal on the projector.
Then plug the RS232C connector on the other end of the cable into an RS232C port
on the computer.
Open Windows Explorer, navigate to the location where you stored the upgrade files,
Then double click the TDPWRI2_0001E.EXE.
The Upgrade Wizard appears. Select “Com port” and setup the Baud Rate is “115200”,
Data Bits is “8”, Stop Bits is “1”, Parity is “None”, RTS is “Diable” and CTS is “Disable”.
Click the Browse button to open the Select File Dialog box.
43
To Next Page
Loading...
