7-2 User’s Manual
HW Setup
General
This window displays the BIOS version and contains two buttons: Default
and About.
Setup
This field displays BIOS Version and date.
Display
This tab lets you customize your computer’s display settings for either the
internal LCD screen or for an external monitor.
Power On Display
Lets you use the display to be used when the computer is booted (This
setting is only available on Standard VGA mode and not available on
Windows Desktop).
Default Return all HW Setup values to the factory
settings.
About Display the HW Setup version.
Auto-Selected Selects an external monitor if one is connected.
Otherwise, it selects the internal LCD (Default).
LCD + Analog RGB Selects both the internal LCD and external
monitor for simultaneous display.
If the connected external monitor does not support the SVGA mode,
selecting the LCD + Analog RGB mode will not display the screen on that
monitor.
At Windows start-up, the screen is displayed on the external monitor if it
was connected at the time of the previous power-off, and is found at the
start-up. Otherwise, the screen is displayed on the internal LCD.
To Next Page
Loading...
