User’s Manual 7-1
TECRA M3
Chapter 7
HW Setup
This chapter explains how to use TOSHIBA HW Setup program to
configure your computer. And the method of a setup of Execute-Disable Bit
Capability and TPM is explained. TOSHIBA HW Setup lets you configure
settings for General, Display, Boot Priority, Keyboard, CPU, LAN, Device
Config, Parallel/Printer and USB.
Accessing HW Setup
To run HW Setup, click start, click Control Panel, click Printers and
Other Hardware and select TOSHIBA HWSetup.
HW Setup window
The HW Setup window contains the following tabs: General, Display, Boot
Priority, Keyboard, CPU, LAN, Device Config, Parallel/Printer and USB.
There are also three buttons: OK, Cancel and Apply.
OK Accepts your changes and closes the HW Setup
window.
Cancel Closes the window without accepting your
changes.
Apply Accepts all your changes without closing the HW
Setup window.
To Next Page
Loading...
