LED indication
Condition Solution
LED-2 LED-1
OFF Green (solid) The TV is
operating
properly
OFF Red (Solid) Standby with
Power-On
Green Red Mode set to
(solid) (solid) Active standby*
OFF Green Sleep timer*
(solid)
Green Red On timer**
(solid) (solid)
OFF RED blinks Power protect
0.5 sec cycle detection
OFF Red blinks Abnormal
1 sec cycle operation of
BUS line
OFF 2 times Abnormal
flashing with operation
2 sec interval (initialisation
error)
Turn OFF the TV
and unplug the
power cord. Plug
the power cord
back in again and
turn ON the TV.
* Digital only
** Analogue only
43
Questions and Answers continued
Cleaning the screen and cabinet…
Turn off the power, clean the screen and cabinet with a soft, dry cloth. We recommend that you do not use any proprietary polishes or
solvents on the screen or cabinet as this may cause damage.
Disposal…
The following information is only for EU-member states:
The use of the symbol indicates that this product may not be treated as household waste. By ensuring this product is
disposed of correctly, you will help prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about
recycling of this product, please contact your local city office, your household waste disposal service or the shop where
you purchased the product.
A
Connect the source via a SCART lead and play.
Select Manual setting from the SET UP menu.
Why are the colours wrong when an NTSC
source is played?
Q
Set the Colour to Auto. and exit.
Go to the Picture settings menu and adjust
the tint.
1
2
Manual setting
Colour system: Auto.
EXT2 A V C R
OK
Store
MENU
Back
EXIT
Watch TV
A
When put into standby the television’s active
standby will automatically search all available
channels for downloads, provided Auto upgrade is On.
The time it takes to do this may vary.
Why does the GREEN Active Standby LED
sometimes take longer to go out?
Q
A
Check the table below .
Why are the LEDs on the front of the television
flashing?
Q
A
If settings on connected REGZA-LINK equipment
are changed the equipment may fail to work
correctly with television. Removing the HDMI cable then
replacing it may help. If not turn off the television, remove
the power cable from the wall socket, then plug the
television back in and switch on.
Why doesn’t REGZA-LINK work?
Q
A
Some early HDMI equipment may not work
properly with the latest HDMI television products,
due to new standard adoption. Try setting Lip Sync
Latency to Off.
Why is there no sound or picture when in
HDMI mode?
Q
gg
To Next Page
Loading...
