6. Please empty the dirty water tank and place H1 on the charging station vertically, run the
self-cleaning mode to clean the roller brush, dirty water tank, HEPA filter set, and brush
guard after each use.
****** Important tips:
• H1 is to be used on indoor hard floors, such as sealed wood, tile, vinyl, marble, etc, use on
a rough surface may not get the best performance.
• Please DO NOT use H1 to clean the long-pile rugs.
• Please DO NOT use H1 to clean the delicate rugs, silk, or similar floors.
• The Dirty Water Tank must be cleaned as soon as the cleaning work is done or it will get
stinky.
• Please DO NOT bend over it before emptying the Dirty Water Tank, otherwise, dirty water
will flow into the vacuum motor and damage the appliance.
Self-Cleaning
H1 can clean its roller brush and its pipe automatically on the charging station.
1). Please make sure there is enough clean water in the clean water tank. Empty dirty water
tank before self-cleaning.
2). Place H1 on the charging station, and plug in the power source properly.
Attention:
Please make sure the clean water tank, dirty water tank, the HEPA filter, the brush guard are
properly installed when starting self-cleaning.
Care and Maintenance
Please unplug the power supply, and turn off the switch before care and maintenance.
1. For daily care and maintenance, use a soft dry mop to wipe the main body, and the
charging station; use a soft damp mop to wipe the brush base, and scraper.
2. Dirty water tank cleaning
3). Press the Self-Cleaning button , H1 will start electrolysis first, after that, it will enter into the
self-cleaning mode. It will spray clean water to clean the roller brush and pipe automatically,
meanwhile, it will vacuum the dirty water and dirt into the dirty water tank.
4). It cleans the dirty water tank, HEPA filter set, and the brush guard, etc in self-cleaning. After
each self-cleaning, please empty dirty water tank to avoid getting stinky.
mode is finished to avoid them getting stinky.
18 ENGLISH
To Next Page
Loading...