6. Suction inlet, water spray nozzle, metal scraper cleaning.
1). Use a cleaning tool to remove the debris at the suction inlet.
2). Wipe the water spray nozzle, with a damp cloth to avoid blocking.
3). Use a cleaning tool to remove the debris on the metal scraper, then wipe it with a
damp cloth.
Spray Nozzel A
Suction inlet
Metal Scraper
Spray Nozzle B(8 sets)
Brush Guard
7. Charging Station and Holders Cleaning
1). Unplug the power supply and take H1 out before cleaning.
2). Pour out the dirty water in Charging Station (if there is), and use a soft dry mop to
wipe the charging station, brush holder, and HEPA filter holder.
8.Storage
1). Please dry the main body, clean water tank, dirty water tank, brush base, and HEPA
set, Charging Station, brush holds, and HEPA holder, then store them.
2). The roller brush can be stored in the brush holder.
******Notice:
• The Dirty Water Tank must be cleaned and dried after every single cleaning to avoid
mildew or smell.
• The machine must be stored in a dry and ventilated place without heat sources.
• Please keep the machine away from direct sunlight.
• H1 should be fully charged every 3 months at least to avoid battery damage.
20 ENGLISH
To Next Page
Loading...