Signal Type: choose signal type for the boat.
- PWM: Enable to match the boat with PWM signal.
- PPM：Enable to match the boat with PPM signal.
Channels Reverse: is used to correct the running direction of motor
(or rudder) after you found them did not run the correct direction as
expected.
For example, if your boat are with 2 engines, and you found the engine
suck in air (or the boat turning around on the water). When you want
it to go straight, then you need to enable the channel reverse.
27
Receiver Config
Used to choose signal type and engine type for the boat.
Note: this menu appears only when you choose “Other”
for the menu of Boat Type Config
.
To Next Page
Loading...
