TOTALINE 1 For All - Adjust the heating set-point for Unoccupied periods; Select the day for Occupied 1

Programming Occupied & Unoccupied Periods
Press
Press
Press
Press
Continued
MODE
MODE
MODE
MODE
Occupied 1
74
Occupied
COOL
1
74
72
Occupied
COOL
HEAT
1
85
unoccupied
COOL
Page 9
Press the MODE button. While holding MODE,
press the UP button for two seconds to enter
time period programming.
MODE
Select the maximum # of
occupied periods to be
used on any one day.
Typically, most installations
use only Occupied 1.
(1,2 or 3)
Adjust the cooling
setpoint for Occupied 1.
(35 - 99, OF )
Adjust the heating
setpoint for Occupied 1.
(OF, 35 - 99 )
Adjust the cooling
setpoint for unoccupied
periods.
(35 - 99, OF )
Use the Programming Worksheet on the back cover
to help with this section.