ValueLine Series Electric Fireplace
www.touchstonehomeproducts.com 800.215.1990
23
Wall Mounted Installation – cont.
8. Once completed installing crystal embers or fire log, reinstall glass panel. The hooks on the back of the glass
panels fit into the slots on the side of the firebox. Once in the slots, the glass panel goes down and locks into place.
NOTE: The 5 screws that were removed earlier during the removal of the glass panel are for shipping purposes
ONLY. They will not need to be reinstalled in a recessed application.
Operating Fireplace
Once the fireplace has been plugged into a grounded outlet, the fireplace is now ready for operation. Ensure that
the house circuit breakers for the power supply are turned on.
Power
Plug the power cable into a 110v 15 amp grounded outlet. Make sure the outlet is in good condition and that the
plug is not loose. NEVER exceed the maximum amperage for the circuit. DO NOT plug other appliances into the
same circuit.
A main ON/OFF power switch controls the power to the fireplace. In the “O” position, the fireplace controls will
not operate. In the “ | ” position, the remote control and control panel can be used to control the fireplace.
To Next Page
Loading...
