ValueLine Series Electric Fireplace
www.touchstonehomeproducts.com 800.215.1990
24
Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the
heater will automatically TURN OFF. To reset, please do the following:
1. Unplug the power cord from the outlet.
2. Turn ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes for fireplace to cool down.
3. Inspect the fireplace to make sure no vents are blocked or clogged with dust or lint. If they are, use a vacuum to
clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional. If the outlet is OK, please
contact our customer support department at 800-215-1990.Methods of Operation
This electric fireplace can be operated by the CONTROL PANEL, located in the bottom right corner of the front
glass panel, or by the REMOTE CONTROL. The operation and functions of both methods are the same.
Method of Controls
Control Panel
The fireplace is equipped with a manual control panel built into the front glass panel.
***NOTE: The controls on the manual control panel are the same as the wireless remote control. Please see p.
23 for manual control functions.
To Next Page
Loading...
