Touchstone 80018 - Remote Control Operation

ValueLine Series Electric Fireplace
www.touchstonehomeproducts.com 800.215.1990
25
Remote Control Operation
 This remote control uses one CR2025 3v battery.
 Instructions for battery installation are located on the back of the remote control.
 To improve operation of the remote control, aim the remote control at the front of the fireplace. DO NOT
PRESS the buttons too quickly. Give the unit time to respond to each command.
 NOTICE: NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.
BUTTON FUNCTION ACTION & INDICATION
POWER
ON: Enables control panel functions and remote control.
Turns on the flame effect.
OFF: Disables control panel functions and remove control.
Turns off the flame effect.
1. Press once. Power turns on and flame
effect turns on. All functions enabled.
2. Press again. Flame effect turns off. Unit
goes to standby. All functions turn off.
TIMER
TIMER button: Control time settings to turn off fireplace
at selected time.
Settings range from 1 hour to 9 hours.
1. Press once. Indicator light turns on.
Timer is set to 1 hour.
2. Press again until desired setting is
reached. Indicator lights show setting.
FLAME COLOR
FLAME COLOR button: Changes the flame color.
NOTE: Flame effect stays on until power button is turned
off. Flame effect must be on for heater to turn on.
1. Press once to change the flame color.
2. Press again until desired flame color is
reached.
FLAME BED
COLOR
FLAME BED COLOR button: Changes the color of the
flame bed (log or crystals).
1. Press once to change the color of the
flame bed (log or crystals)
2. Press again until desired setting is
reached.
HEATER
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame effect is on.
NOTE: To prevent overheating, the heater fan will blow
cool air for 8-10 seconds before the heater turns on, and
after the heater turns off.
1. Press once. Temperature indicator lights
up. Temperature range is 62ºF to 86ºF
2. Press again: To change to the desired
temperature.
To change from F to C, press and hold the
temperature button for 10 seconds.
TEMPERATURE
TEMPERATURE button: Changes the temperature of the
heater.
NOTE: The heater only works when the flame effect is on.
NOTE: To prevent overheating, the heater fan will blow
cool air for 8-10 seconds before the heater turns on, and
after the heater turns off.
1. Press once. Indicator lights up. Fan blows
cool air for 10 seconds and 675W heater
turns on and blows warm air.
2. Press again: Indicator lights up. 1300W
heater turns on and blows hot air.
3. Press again. Heater turns off.