Tower Hobbies VL70FLEXI - Troubleshooting

10
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The vacuum will not
work.
The battery is low.
Ensure the vacuum cleaner is
fully charged.
Blockage to the dust tank
or lter.
Check that there are no
blockages to the dust tank
or lter and remove as
necessary.
The motor protective
thermostat
has kicked in.
Allow the unit to cool for 1
hour, then empty the dust
tank and clean all of the
lters.
The vacuum will not
pick-up or the suction
power is weak.
The dust container is
full or the lter needs
cleaning.
Empty the dust container and
clean the lter.
Potential blockages in the
dust tank or lter.
Check for blockages and clean
the lter and dust tank.
Dust is escaping from
the vacuum.
The lter may installed
incorrectly.
Ensure the lter is correctly
installed inside the unit.
dust container may be
full.
Empty the dust container and
reassemble the lter system.
There is a strange
noise coming from the
vacuum.
The airow may be
restricted or blocked.
Check for blockages and clean
the lter and pole.
TROUBLESHOOTING