Tower Hobbies VL70FLEXI - Cleaning and Care

9
EMPTYING THE DUST TANK
Hold the unit over a bin and press the
dust tank quick release button. Empty the
contents of the dust tank. Once empty,
push the cover back into place until there
is an audible click.
CLEANING THE FILTER
1. Press the lter release button to open
the lter housing.
2. Remove the lter from the dust tank.
3. To clean the lter, rinse it under running
water and leave it to dry thoroughly.
WARNING! The lter is NOT washing
machine safe. DO NOT place the lter into
the washing machine.
NOTE: Allow the lter to dry for a period of
at least 24 hours before placing it back into
the unit. DO NOT use a hair dryer to dry the
lter. Air-dry only.
4. Once the lter is thoroughly dry, place
it back into its corresponding slot inside
the dust tank. Ensure the lter is rmly
secured into place before attempting to
use the vacuum.
CAUTION! DO NOT use the vacuum cleaner
without the lter in place.
NOTE: If the lter appears damaged or
is not performing correctly, it should be
replaced. It is recommended to replace the
lter approximately every three months.
CLEANING THE UNIT BODY
1. Before cleaning the unit body, ensure
the unit is disconnected from the mains
supply and not in operation.
2. Use a damp cloth to clean the unit
body. Never use any abrasive cleaning
materials or solvents, as these could
cause damage to the surface of the unit.
WARNING! DO NOT allow any liquids into
the unit, as this could cause damage to
the electrical components and cause it to
malfunction.
CLEANING AND CARE
CLEANING THE ANTI TANGLE
BRUSH BAR
1. Unscrew the brush bar cap on the side
of the oorhead.
2. Pull the bar out from within the
oorhead.
3. Remove uff, hairs and other residues
from the brush, then t it back into
place.
4. Once the brush bar has been securely
tted into place, screw the brush bar
cap back onto the main body of the
oorhead to lock it into place. Ensure
the bar is rmly secured into place
before attempting to use the unit.
CLEARING BLOCKAGES
If the dust tank is overlled, the lter is
clogged up, or the vacuum picks up a
larger piece of debris, the vacuum may
become clogged.
Should this occur, carry out the following
steps to unclog the vacuum:
1. Check the dust tank and empty it if
necessary.
2. Check the lter for any debris and rinse
it under running water if necessary, as
detailed in the sections above.
3. Detach any attachments from the unit
and check for blockages.
STORING THE APPLIANCE
1. Store the appliance in a cool, dry place,
preferably inside its original packaging,
and out of the reach of children.