拓陽精密科技 TOYAN ENGINE
You can also purchase TOYAN series of water-cooled heat dissipation accessories, so that your
engine will be able to maintain long-term stable work.
Reminder!
When leaving the factory, each engine has completed the needle setting. If you have adjusted the
needle during use, it is recommended that the main needle be adjusted to 2.0 laps and the auxiliary
needle to 1.5 laps. Since the methanol engine needs to keep the filament temperature of the
electric plug in order to realize ignition, when the engine is in the oil-rich state for a long time at
low speed, the filament temperature will gradually decrease, resulting in ignition difficulties, so it
is necessary to pull high speed oil at intervals to avoid oil-rich at low speed.
Since the four-stroke engine requires a large amount of air intake, it is very important to Set the
throttle-stop screw so that the minimum throttle opening (idle setting) is approximately 1.5mm. For the
use of various engine enthusiasts, do not use strong force to twist the throttle screw to adjust the size of
the throttle opening. but to loosen the throttle screw and then pull the throttle arm to adjust. As shown
in the figure:
To Next Page
Loading...
Need help?
General
