4Runner_Navi_U (L/O 0208)
176
2003 MY 4Runner Navigation from Aug. ’02 Prod. (OM35799U)
3. “MODE” button
Push the “MODE” button to select an
audio mode. Each time you push this
button, the system changes between the
radio, cassette tape player, compact disc
player and DVD player.
To turn the audio system on, push the
“MODE” button.
To turn the audio system off, push and
hold the “MODE” button until the system
turns off.
NOTICE
To ensure the correct audio/video
system operation:
Be careful not to spill beverages
over the system.
Do not put anything other than a
cassette tape or compact disc into
the slot.
Do not put anything other than a
magazine into the DVD player.
The use of cellular phone inside or
near the vehicle may cause a noise
from the speakers of the system
which you are listening to. Howev-
er, this does not indicate a mal-
function.
RADIO RECEPTION
Usually, a problem with radio reception
does not mean there is a problem with
your radio—it is just the normal result of
conditions outside the vehicle.
For example, nearby buildings and terrain
can interfere with FM reception. Power
lines or telephone wires can interfere with
AM signals. And of course, radio signals
have a limited range. The farther you are
from a station, the weaker its signal will
be. In addition, reception conditions
change constantly as your vehicle moves.
Here are some common reception prob-
lems that probably do not indicate a
problem with your radio:
FM
Fading and drifting stations—Generally,
the effective range of FM is about 40 km
(25 miles). Once outside this range, you
may notice fading and drifting, which in-
crease with the distance from the radio
transmitter. They are often accompanied
by distortion.
Multi–path—FM signals are reflective,
making it possible for two signals to
reach your antenna at the same time. If
this happens, the signals will cancel each
other out, causing a momentary flutter or
loss of reception.
Car audio/video system
operating hints
To Next Page
Loading...
