Toyota 2016 RAV4 - Changing the Pre-Collision Warning Timing

RAV4_OM_OM42A41U_(U)
243
4-5. Using the driving support systems
4
Driving
■ Changing the pre-collision warning timing
Press or of the meter control switches and select
on the multi-information display.
Press or of the meter control switches and select ,
and then press .
Select “Sensitivity” and then press .
Each time is pressed, the operation timing of the pre-collision sys-
tem will be changed.
The operation timing setting is retained when the engine switch is
turned off.
Far
The system functions will begin
to operate earlier than with the
default timing.
Middle
This is the default setting.
Near
The system functions will begin
to operate later than with default
timing.
1
2
3
1
2
3