524
RAV4_OM_OM42A41U_(U)
6-4. Using the other interior features
■ Programming HomeLink
®
Press and release the HomeLink
®
button you want to program
and check that the HomeLink
®
indicator light flashes (orange).
Perform within 60 seconds of , or the indicator light will
stop flashing and programming will not be able to be completed.
Point the remote control
transmitter for the device at
the rear view mirror, 1 to 3 in.
(25 to 75 mm) from the
HomeLink
®
buttons.
Keep the HomeLink
®
indicator
light in view while programming.
For U.S.A. owners
Press and hold the handheld
transmitter button until the
HomeLink
®
indicator light
changes from slowly flashing
orange to rapidly flashing
green (rolling code) or contin-
uously lit green (fixed code),
then release the button.
Programming an entry gate (for U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control transmitter button at 2 sec-
ond intervals, repeatedly, until the HomeLink
®
indicator light
changes from slowly flashing (orange) to rapidly flashing (green)
(rolling code) or continuously lit (green) (fixed code).
Test the HomeLink
®
operation by pressing the newly pro-
grammed button and observing the indicator light:
● Device with fixed code: If the indicator light is solid/continuous,
programming has been completed and your garage door or
other device should operate when the HomeLink
®
button is
pressed and released.
1
3 1
2
3
3
4
To Next Page
Loading...
