ā05 AVALON_U (L/O 0501)
248
2005 AVALON from Jan. ā05 Prod. (OM41408U)
The garage door opener (
ī
Universal Transceiver) is manufactured
under license from HomeLink
ī
and can
be programmed to operate garage
doors, gates, entry doors, door locks,
home lighting systems, and security
systems, etc.
(a) Programming the HomeLink
ī
The HomeLink
ī
in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
HomeLink
ī
, install a new battery in the
hand- held transmitter prior to program-
ming.
The battery side of the hand- held trans-
mitter must be pointed away from the
HomeLink
ī
during the programming pro-
cess.
For Canadian users, follow the procedure
in āProgramming an entrance gate/Pro-
gramming all devices in the Canadian
marketā.
1. Decide which of 3 HomeLink
ī
buttons
you want to program.
2. Place your hand- held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
the surface of the HomeLink
ī
.
Keep the indicator light on the HomeLink
ī
in view while programming.
3. Simultaneously press and hold the
hand- held garage transmitter button
along with the selected HomeLink
ī
but-
ton.
4. When the indicator light on the
HomeLink
ī
changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
ī
by
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
āRolling Codeā type. Press and hold the
programmed HomeLink
ī
button. The ga-
rage door has the rolling code feature if
the indicator light (on the HomeLink
ī
)
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the āRolling Codeā type, proceed to the
heading āProgramming a rolling code sys-
temā.
6. Repeat steps 2 through 5 for each re-
maining HomeLink
ī
button to program
another device.
Garage door opener
To Next Page
Loading...
