π Transfer private call to hands-free
1 Press and hold the Mode button.
The system responds: Call menu. {Say a command}.
2 Say Hands-free Mode.
The system responds: Hands-free mode and transfers the call to the hands-free
system.
ó Note: Pressing and holding the Seek up button also transfers the call the hands-free
system.
ó Note: Some handset devices disconnect the Bluetooth® link to the system when the
call is switched to privacy mode. In this case, the Call menu will not be available. To
switch the call to hands-free, use the voice command Connect <device name>.
Send DTMF tones
1 Press and hold the Mode button.
The system responds: Call menu. {Say a command}.
2 Say Enter <digits> to send digits as DTMF tones.
You can also use * and # characters.
ó Note: You can send DTMF tones from the handset device’s keypad.
π Hold a call
Press the Seek up button to put an active call on hold.
Press the Seek up button again to resume a call on hold.
π Call waiting
While in a call, an audible beep signals an incoming call. Press the Seek up button to place
the active call on hold and answer the waiting call. To reject a waiting call, press the Seek
down button.
π Switch between active call and held call
1 Press and hold the Mode button.
The system responds: Call menu. {Say a command}.
2 Say Switch Call.
The system responds: Switching active calls.
ó Note: Pressing the Seek up button switches between held and active calls.
To Next Page
Loading...
