15
OVERVIEWFEATURES & OPERATIONSTOYOTA SAFETY SENSESAFETY & EMERGENCY FEATURES
Hold the steering wheel, push the lever down, set angle and length, and return the
lever.
NOTE: Do not attempt to adjust while the vehicle is in motion.
When starting the engine, the engine switch may seem stuck in OFF. To free it, turn
the key while turning the steering wheel slightly left and right.
1. When the liftgate reaches the desired height, push the rear liftgate close-button
(on the door jam of the liftgate) once. Press and hold the button until the buzzer
sounds (4 times).
2. To reset the height, with the liftgate open and not moving, press and hold the
rear liftgate close-button for approximately 7 seconds until the buzzer sounds 4
times, and continue to hold until it buzzes 2 times again, then let go. Push the
same button to close the liftgate. When you next open the liftgate, it will open to
the maximum height.
For more details, refer to the Owner’s Manual.
Rear door-Power Liftgate (if equipped)
Instrument panel
Power liftgate switch on the back door
Liftgate opener switch (open only)
Lock switch on the back door
Open: Push and hold
Close: Push and hold again
When the back door is closed, all of the doors
will lock simultaneously and operation signals
will indicate that all of the doors have been
locked.
ADJUSTING THE POWER LIFTGATE HEIGHT
OPENING/CLOSING POWER LIFTGATE
Press
Press
Press
Steering lock release (if equipped)
176137_Corolla_Cross_QRG_GUTS.indd 15 8/6/21 5:14 PM
To Next Page
Loading...
