EasyManua.ls Logo

Toyota COROLLA CROSS 2022 - Road Sign Assist (RSA)

Toyota COROLLA CROSS 2022
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
TOYOTA SAFETY SENSE
Road Sign Assist (RSA)
Using an intelligent camera, Road Sign Assist (RSA) is designed to detect speed
limit signs, stop signs, do not enter signs and yield signs, and display them on the
Multi-Information Display (MID).*
* All vehicle actions must be driver-initiated and are not automated.
Refer to the Toyota Owner’s Manual for additional information and limitations.
RSA DISPLAY
When the driving support system
information is selected, a maximum of
3 signs can be displayed.
When a tab other than the driving support
system information is selected, the following
types of road signs will be displayed.
• Speed limit sign
• Do Not Enter sign (when notification
is necessary)
TEMPORARILY SWITCHING TO THE LOW BEAMS
Pull the lever toward you and then return it to its original position to switch to the
low beams temporarily.
The high beams are on while the lever is pulled toward you, however, after the
lever is returned to its original position, the low beams remain on for a certain
amount of time. Afterwards, the Automatic High Beams will be activated again.
NOTE: It is recommended to switch to the low beams when the high beams
may cause problems or distress to other drivers or pedestrians nearby.
Refer to the Toyota Owner’s Manual for additional information on AHB operation,
settings adjustments, limitations, and precautions before attempting to use it.
SUPPORTED TYPES OF ROAD SIGNS
SETTING RSA
(1) Press “ ” switches and select from the Multi-Information Display (MID).
(2) Press “ ” switches and select “
” and then press “ .” The setting screen
is displayed.
(3) Press “
” each time to change the setting.
(4) Press “
” to go back to the menu.
Note: If the vehicle was last turned off while a speed limit sign was displayed
on the Multi-Information Display (MID), the same sign displays again when the
vehicle is turned on.
Refer to the Toyota Owner’s Manual for additional information on RSA operation,
settings adjustments, limitations, and precautions before attempting to use it.
176137_Corolla_Cross_QRG_GUTS.indd 46 8/6/21 5:15 PM

Table of Contents

Related product manuals