Toyota COROLLA CROSS 2022 - Stop & Start System; Hill-Start Assist Control (Hac)

28
FEATURES & OPERATIONS
Stop & Start system
The Stop & Start system stops and starts the engine according to brake pedal
or shift lever operation when the vehicle is stopped, such as at a stoplight,
intersection, etc., in order to improve fuel economy and reduce noise pollution
caused by the engine idling.
Press the Stop & Start cancel switch to disable the Stop & Start system.
The Stop & Start cancel indicator will illuminate. Pressing the switch again will
enable the Stop & Start system and the Stop & Start cancel indicator will turn off.
Stopping the engine
While driving with the D shift position selected, depress the brake pedal and stop
the vehicle. The engine will stop automatically.
When the engine stops, the Stop & Start indicator will illuminate.
Restarting the engine
Release the brake pedal. The engine will start automatically.
When the engine starts, the Stop & Start indicator will turn off.
STOP & START SYSTEM OPERATION
DISABLING THE STOP & START SYSTEM
If the engine is stopped by the Stop & Start Engine System when the vehicle is
on an incline, brake force is temporarily maintained to prevent rolling backwards
until the engine is restarted and drive force is generated.
When drive force is generated, the maintained brake force is automatically
canceled.
Refer to the Owner’s Manual for limitations and more details on this system before
attempting to use it.
HILL-START ASSIST CONTROL (HAC)
The rear view monitor system displays an image of the view from the bumper of
the rear area of the vehicle. The camera for the rear view monitor system is located
above the license plate.
To adjust the image on the rear view monitor screen, press the “MENU” button and
select “Display.” Select “Camera” to adjust the screen contrast and brightness.
Refer to the “Owner’s Manual” and the “Multimedia Owner’s Manual” for limitations
and more details on this system.
The VSC OFF switch can be used to help free a stuck vehicle in surroundings like
mud, dirt or snow. While the vehicle is stopped, press switch to disable the TRAC
system.
To disable both VSC and TRAC systems, press and hold the switch for at least 3
seconds.
Refer to the Owner’s Manual for limitations and more details.
176137_Corolla_Cross_QRG_GUTS.indd 28 8/6/21 5:14 PM