Toyota HILUX ‘A’ DECK - Power Harness Entry into Tub; Feeding Harness Through 30 mm Hole; Cleaning and Securing Front Tub Panel

Page 25 of 34Accessory Part No. PZQ70-89870ISSUE 4: 09/10/18
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
TC0403c
60. Feed a guide wire (1) through the Ø30mm hole (2) From underneath the LHS front of the tub, retrieve the guide wire
and secure it to the Power Harness connectors. Pull the Power Harness (1) through the hole (2) and into the tub. Ensure
a good seal has been achieved between the Ø30mm grommet (3) and Ø30mm tub panel hole. Note: Ensure the larger
grommet (Ø30mm) is used. See Dia #60.
Diagram #60
61. From underneath the LHS front tub area, clean the front tub panel (1) with the supplied Cleaning Pad and apply Primer
Stick. Allow to dry. Secure the Power Harness to the front tub panel using the supplied Cable Tie Mount and Cable Tie (2).
See Dia #61.
Diagram #61
62. Underneath the vehicle, locate the Power Harness (1). See Dia #62.
Diagram #62
2
3
1
2
Important
Allow the areas cleaned with the supplied Cleaning
Pad and Primer Stick to dry before continuing.
21
Front of tub outer panel LHS
Important
Ensure the Power Harness (1) is kept clear of all
sharp edges or moving parts.
1
Front of vehicle