15. Use the primer supplied to prime top of the header rail, where the header rail seal will sit. Remove the tape liner from
the bulb seal (4) and start applying the seal 100mm from one end of the header rail. Note the seal orientation shown in the
cross section. A
pply firm vertical pressure to the bulb seal along its length to ensure good and even adhesion.
Rubber
seal must be positioned correctly as shown.
Follow the diagram above. See Dia #15.
5
5
4
4
13. To prevent water ingress, apply a bead of silicon (non-acetic) along the edge of both the LHS & RHS inspection panel
inside the tub, as shown. See Dia #13.
FRONT OF
THE VEHICLE
COMPLETE THIS STEP ONLY IF VEHICLE IS FITTED WITH A UTELINER
UTELINER
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
TC0403c
Page 9 of 34Accessory Part No. PZQ70-89870
ISSUE 4: 09/10/18
Diagram #13
14. Reinstall the uteliner. See Dia #14.
Diagram #14
Diagram #15
100mm
LHS RHS
100mm
To Next Page
Loading...
