FRONT
MASKING TAPE
SIDE VIEW
CB B
A
A
10mm
10. Set the drill depth to 10mm. Drill Ø3mm pilot holes first. Drill Ø7mm holes in positions A and B and Ø9mm in
position C. Repeat for the other side of the tub. Apply rust inhibitor to all drilled holes. See Dia #10.
Ø7mm
Ø3mm
1
2
Ø7mm Ø9mm
3 4
Hard Tonneau Cover, A-Deck
Accessory Part No. PZQ70-89870
TC0403c
Page 8 of 34Accessory Part No. PZQ70-89870ISSUE 4: 09/10/18
11. Secure the Header Bar to the tub with 7 rivets (17). See Dia #11.
4
17
17
Diagram #10
Diagram #11
SILICONE
BEAD
SILICONE
BEAD
12. To help prevent water ingress into the tub, apply a bead of silicon (non-acetic) along both gaps between the Header
Bar edge and side panels. Use a soapy water solution and clean fingers to manipulate and clean up the silicone bead
after applying. See Dia #12.
Diagram #12
To Next Page
Loading...
