TP-Link AC750 - WAN Connection Configuration

15
Chapter 4 Congure the Router
4. 3. Operation Mode
The router supports three operation modes: Wireless Router mode, Access Point mode
and Range Extender.
4. 3. 1. Wireless Router Mode
The default Wireless Router mode is required most commonly. In this mode, the device
enables multiple users to share the internet connection via ADSL/Cable Modem.
For hardware connection, refer to Connect Your Router.
4. 3. 2. Access Point Mode
In this mode, the device can be connected to a wired network and transform the wired
access into wireless one. If you already have a wired router, you can use this mode.
Refer to Configure the Router in Access Point Mode session for detailed information.
4. 3. 3. Range Extender Mode
In this mode, the device can copy and reinforce the existing wireless signal to extend
the coverage of the signal, especially for a large space to eliminate signal-blind corners.
Refer to Configure the Router in Range Extender Mode session for detailed information.
4. 4. Network
4. 4. 1. WAN
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Network > WAN.
3. Configure the IP parameters of the WAN and click Save.
Dynamic IP
If your ISP provides the DHCP service, please select Dynamic IP, and the router will
automatically get IP parameters from your ISP.
Click Renew to renew the IP parameters from your ISP.
Click Release to release the IP parameters.