TP-Link Archer C4000 - FAQ; What should I do if I forget my wireless password?; What should I do if I forget my web management password?; What should I do if I can’t log in to the router’s web management page?

102
Chapter 13 Manage the Router
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.
2. Go to Advanced > System Tools > System Parameters. Focus on 2.4GHz/5GHz WDS
section.
• To bridge a network by Survey/Scan feature:
1. Enable the WDS Bridging feature.
2. Click Survey to scan all available networks and select the network you want to bridge.
The SSID (network name) and MAC Address will be automatically populated. You can
also manually fill in these parameters.
3. Select a Security type and enter related parameters, which should be the same as
the network to be bridged.
4. Click Save.
Note: You need to enable and configure the WDS Bridging feature for the access point as well.
• To bridge a network manually:
1. Enable the WDS Bridging feature.
2. Enter the SSID (network name) and MAC Address of the network to be bridged .
3. Select a Security type and enter related parameters, which should be the same as
the network to be bridged.
4. Click Save.
13. 14. 3. NAT
The router’s NAT (Network Address Translation) feature makes devices on the LAN
use the same public IP address to communicate with devices on the internet, which
protects the local network by hiding IP addresses of the devices.
1. Visit http://tplinkwifi.net, and log in with your TP-Link ID or the password you set for
the router.