INSTALLING YOUR NEW
TP-LINK VR600v WIRELESS ROUTER
Step 1: Open your box and pull out the modem. Make sure you have your username
and password, we sent to you via email handy as you will need this when you reach
step 9.
Step 2: Connect the power adapter to an unused socket on your wall, with the other
end going into the port on your modem labeled ‘Power’.
Step 3: Make sure the DSL cable is plugged into ADSL splitter-Filter to the
telephone jackpoint and the modem is powered on.
Step 4: Make sure to press the power button, located to the side, and ensure your
Power LED begins to glow.
NOTE: If your modem was sent out by us, it will be preconfigured and you can
just plug it in and it’s ready to go.
To Next Page
Loading...
