TP-Link Auranet EAP115 User Manual

69
Check the box to turn on or turn off the LED light of the EAP, and click Save.
4.6 Configure Wi-Fi Control (For EAP115-Wall)
EAP115-Wall has an LED/Wi-Fi button on the front panel. With Wi-Fi Control enabled, you
can press the button to turn on or off both of the Wi-Fi and LED at the same time.
To configure Wi-Fi Control, go to the Management > Wi-Fi Control page.
Check the box to enable Wi-Fi Control.
Note:
You can enable Wi-Fi Control only when the option LED ON/OFF is enabled.
4.7 Configure SSH
If you want to remotely log in to the EAP via SSH, you can deploy an SSH server on your
network and configure the SSH feature on the EAP.
To configure SSH, go to the Management > SSH page.
Follow the steps below to configure SSH on this page:

TP-Link Auranet EAP115 Specifications

General

Frequency	2.4GHz
Mounting	Ceiling / Wall Mounting (Kits included)
Dimensions	7.1 x 7.1 x 1.9 in. (180 x 180 x 47.5mm)
Button	Reset Button
Frequency Band	2.4GHz
Maximum Data Rate	300Mbps
Operating Temperature	0°C to 40°C (32°F to 104°F)
Wireless Standards	IEEE 802.11n
Signal Rate	Up to 300Mbps
Antenna Type	Internal
Ethernet Ports	1 * 10/100Mbps Ethernet Port (RJ-45)
Interface	1 * 10/100M Ethernet Port(RJ45)
Wireless Functions	Multiple SSIDs
Wireless Security	WPA/WPA2, WPA-PSK/WPA2-PSK
Management	SNMP, Web-based Management
Operating Humidity	10% to 90% non-condensing