21
Gigabit L2 Managed Switch
Conguration
■
Parity: none
■
Stop bits: 1
■
Flow control: none
5. The DOS prompt ”T2500G-10TS>” will appear after pressing the Enter button as
Figure 5-4 shows. It indicates that you can use the CLI now.
Figure 5-4 Log in the Switch
■
Logon by Telnet
To log on to the switch by a Telnet connection, please take the following steps:
1. The switch supports two access mode, login local mode (the default mode) and
login mode. Here we take login local mode as an example.
2. Make sure the switch and the PC are in the same LAN.
3. Click Start and type in cmd in the Search programs and files window and press
the Enter button.
Figure 5-5 Open the RUN window
4. Type telnet 192.168 .0.1 in the command prompt shown as Figure 5-6, and press
the Enter button.
Figure 5-6 Connecting the Switch
To Next Page
Loading...
