TP-Link NC200 - Basic → Wireless Connection

NC200
Cloud Camera, 300Mbps Wi-Fi
Click Save to save and enable the settings.
3.3.3 Basic → Wireless Connection
The camera’s wireless function is enabled by default. This function helps to connect your camera
to a wireless network wirelessly. If you don’t want to use this function, just select the Disable
option.
 Wireless Network Name: Displays the wireless network’s name. Make sure the camera and
your PC connect to the same wireless network, or your PC can't access the camera.
 Signal: Displays the strength of the wireless signal.
 Security: Displays the wireless network’s security mode.
 MAC Address: Displays the MAC address of the front device.
To connect your camera to a wireless network, follow the steps below:
1. Click Scan to scan the available wireless network and to refresh the Wireless Network List.
2. Select a wireless network from the wireless network list.
3. If the wireless network’s security mode is None, simply click Connect. If the security mode is
one requiring for a password, enter the wireless network’s password and then click Connect.
14