Installation Guide
PoE InjectorPower Socket Ethernet Device
(switch, router, etc.)
PoE Injector
LAN IN
PWR
DC 48V
PoE Injector Only
The PoE Injector supplies steady power and data connectivity to a powered device such as PoE IP Camera, PoE
AP and PoE IP Phone through an Ethernet cable.
IP Camera AP IP Phone
Powered Device (PD)
Note:
Set the required voltage
of the non-PoE device
before cable connection.
12V 9V 5V
PoE Splitter
LAN OUT
PWR
DC OUT
PoE Splitter
Non-PoE Device
(suggested power:<12 W)
PoE/PoE+ Switch
PoE Splitter Only
The PoE Splitter can be used with a PoE/PoE+ switch to deliver direct current (DC) power and data to a Non-PoE
device.
PoE Injector PoE SplitterPower Socket
Ethernet Device
(switch, router, etc.)
Note:
Set the required voltage
of the non-PoE device
before cable connection.
12V 9V 5V
PoE Injector
LAN IN
PWR
DC 48V
LAN OUT
PWR
DC OUT
PoE Splitter
Non-PoE Device
(suggested power:<12 W)
PoE Injector & Splitter
The PoE injector and PoE splitter can be used as a kit to supply power and transmit data to a Non-PoE
device.
Some models featured in this guide may be unavailable in your country or region. For local sales information, visit https://www.tp-link.com.
For technical support and other information, please visit
https://www.tp-link.com/support, or simply scan the QR code.
To ask questions, find answers, and communicate with TP-Link users or
engineers, please visit https://community.tp-link.com to join TP-Link
Community.
© 2023 TP-Link 7106510639 REV6.20.0
PoE Injector and PoE Splitter
For simplicity, we will take POE150S and POE10R for example throughout the Guide, other models may dier in appearance.
Note: The maximum output power of POE150S is
15.4W. PoE devices that require more than 15.4W are
not supported.