TP-Link Tapo T110 - Setting Up Your Smart Sensor; Pre-Setup Requirements; Adding Sensor in Tapo App; Verifying Device LED Status

5
1. Set Up Your Sensor
Tap the button in the Tapo app, tap
Sensors, and select your model. Follow the
instructions in the Tapo app to complete the
setup.
2. Check the LED & Set Up
Check if the LED blinks. If not, use a pin to
press and hold the Reset button for 5s. Follow
app instructions to complete the setup.
Set Up Your Smart Sensor
Watch setup videos at https://www.tp-link.com/support/download/tapo-t110/
Before You Start
A Tapo Hub is required. Make sure your Tapo
Hub is successfully added via the Tapo app.
OR