Quick Installation Guide
Connecting the Hardware
If you don’t need the phone service, just directly connect the modem router
to the phone jack with a phone cable, then follow steps 3 and 4 to complete
the hardware connection.
ADSL splitter
Phone jack
Connect to the phone (Optional)
2 Connect the modem router to the
ADSL splitter.
3
Turn on the modem router.
1 Connect the ADSL splitter
to the phone jack.
Modem Router
Power adapter
Wireless
On
Power
On
ADSL
On
4
Verify that the hardware connection
is correct by checking these LEDs.
Notes:
1. The ADSL LED takes about 1 to 2 minutes to stabilize.
2. If the Wireless LED is off, please press the WIFI button on the rear
panel for 2 seconds, then check the LEDs again in a few seconds.
150Mbps Wireless N ADSL2+ Modem Router
TD-W8151N
To Next Page
