1
If you currently use a modem, disconnect it now - the Modem Router will
replace your current modem.
If no telephone is needed, please connect the ADSL port of the Modem
Router to the wall jack using the telephone line directly.
Note
Note
Please use only wired network connections to configure the Modem
Router.
Installation
Connect your computer to
the Port labeled “1~4” on
the Modem Router with an
Ethernet cable.
Connect the splitter to the wall
ack using a telephone line,
then use the other telephone
line to directly connect it to the
DSL port on the Modem
Router and the MODEM port
of the splitter, also have the
PHONE port of the splitter
connected to a telephone.
The product model shown in this QIG is TD-W8961ND, as an example.
Note
To Next Page
