Quick Installation Guide
Connecting the Hardware
If you don’t need the phone service, just skip step 1 and directly connect the
modem router to the phone jack with a phone cable, then follow steps 3 and
4 to complete the hardware connection.
300Mbps Wireless N ADSL2+ Modem Router
TD-W8961ND / TD-W8961NB / TD-W8961N
ADSL splitter
Phone jack
Connect to the phone (Optional)
2 Connect the modem router to the
ADSL splitter.
3
Turn on the modem router.
1 Connect the ADSL splitter
to the phone jack.
Modem Router
Power adapter
* TD-W8961ND is used for demonstration in this QIG.
Wireless
On/Flashing
Power
On
ADSL
On
4
Verify that the hardware connection
is correct by checking these LEDs.
Notes
1. The ADSL LED takes about 1 to 2 minutes to stabilize.
2. If the Wireless LED is off, please press the WiFi ON/OFF
button on the rear panel for 2 seconds, then check the
LEDs again in a few seconds.
To Next Page
