-91-
Figure 3-62 IKE Policy
The following items are displayed on this screen:
IKE Policy
Policy Name:
Specify a unique name to the IKE policy for identification and
management purposes. The IKE policy can be applied to IPsec policy.
Exchange Mode:
Select the IKE Exchange Mode in phase 1, and ensure the remote VPN
peer uses the same mode.
Main: Main mode provides identity protection and exchanges more
information, which applies to the scenarios with higher requirement
for identity protection.
Aggressive: Aggressive Mode establishes a faster connection but
with lower security, which applies to scenarios with lower
requirement for identity protection.
Local ID Type:
Select the local ID type for IKE negotiation. IP Address: uses an IP
address as the ID in IKE negotiation. FQDN: uses a name as the ID.
To Next Page
Loading...
