23
¾ DDNS Host: The domain name is applied of this camera.
¾ User name: The user name is used to log into DDNS.
¾ Password: The password is used to log into DDNS.
Please refer to Appendix for more detailed information.
6.1.4 PPPoE
PPPoE: Stands for Point to Point Protocol over Ethernet
A standard builds on Ethernet and Point-to-Point network protocol. It allows your camera with
xDSL or cable connects with broadband network directly, then your camera can dial up and get a
dynamic IP address. For more PPPoE and Internet configuration, please consult your dealer or
ISP.
The camera can directly connect to the xDSL, however, it should be set up on a LAN environment
to program the PPPoE information first, and then connect to the xDSL modem. Power on again,
then the camera will dial on to the ISP connect to the WAN through the xDSL modem.
The procedures are
• Connect to a LAN by DHCP or Fixed IP
• Access the camera, and enter Setting Î Network Î PPPoE as below
¾ PPPoE: To enable or disable the PPPoE service here.
To Next Page
Loading...
