Need help?Do you have a question about the TP-Link TL-SG1428PE and is the answer not in the manual?
General| PoE+ Ports | 24 |
|---|---|
| Switching Capacity | 56 Gbps |
| Forwarding Rate | 41.7 Mpps |
| MAC Address Table | 16K |
| Jumbo Frame | 9 KB |
| Power Input | 100-240V AC, 50/60Hz |
| Dimensions | 440 x 180 x 44 mm |
| Management | Web-based, SNMP |
| Standards and Protocols | IEEE 802.3, 802.3u, 802.3ab, 802.3z, 802.3x, 802.1Q, 802.1p |
| Operating Temperature | 0 to 40 °C |
| Storage Temperature | -40 to 70 °C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Storage Humidity | 5% to 90% (non-condensing) |
| Ports | 24× Gigabit PoE+ Ports, 4× Gigabit SFP Slots |
Provides step-by-step instructions for accessing the switch via its web interface.
Instructions on configuring the switch's IP address using DHCP or manually.
Steps to modify the administrator's username and password for enhanced security.
Procedures for saving and restoring the switch's current configuration settings.
Steps to reset the switch to its factory default configuration settings.
Guide on updating the switch's firmware for new features and performance improvements.
Details on setting port status, speed, duplex mode, and flow control.
Steps to configure Link Aggregation Group (LAG) for increased bandwidth and reliability.
How to view traffic statistics per port, including transmitted and received packets.
To Next Page
