TP-Link TL-SL3428 - Login to the Switch; Login; Configuration

13
L2 Managed Switch
Connection
Chapter 4 Connection
4.1 Ethernet Port
Connect the Ethernet ports of the switch to the network devices by RJ45 cable as the
following figure shows.
L2 Managed Switch
TL-SL3428
RJ45 Cable
RJ45 Port
Figure 4-1 Connecting the RJ45 Port
4.2 SFP Port
Connect the SFP port to a SFP module.
For TL-SL3428, if an SFP transceiver (purchased separately) is installed in a slot and has
a valid link on the port, the associated RJ45 port will be disabled and cannot be used.
L2 Managed Switch
TL-SL3428
SFP Port
Figure 4-2 Inserting the SFP Module
Note:
■
TL-SL3428 supports 100/1000Base-FX SFP module at full-duplex mode. When
using a SFP module, you need log on to the GUI of the switch and configure the
corresponding Speed and Duplex mode on switching
→
Port
→
Port Config page.
■
TL-SL3452 only supports 1000Base-X SFP module at full-duplex mode.
SFP Module