Choose the menu Multicast→IGMP Snooping→VLAN Config to load the following page.
Figure 8-6 VLAN Config
The following entries are displayed on this screen:
¾ VLAN Config
VLAN ID: Enter the VLAN ID to enable IGMP Snooping for the desired
VLAN.
Router Port Time: Specify the aging time of the router port. Within this time, if the
switch doesn’t receive IGMP query message from the router port,
it will consider this port is not a router port any more.
Member Port Time: Specify the aging time of the member port. Within this time, if the
switch doesn’t receive IGMP report message from the member
port, it will consider this port is not a member port any more.
Leave Time: Specify the interval between the switch receiving a leave message
from a host and the switch removing the host from the multicast
groups.
Static Router Port: Select the static router port which is mainly used in the network
with stable topology.
¾ VLAN Table
VLAN ID Select: Click the Select button to quick-select the corresponding VLAN ID
based on the ID number you entered.
99
To Next Page
Loading...
