11
English
1. Turn off all your network devices, including your computer(s), power injector and
the AP.
2. Connect your computer to the LAN port on the power injector with an Ethernet
Cable.
3. Connect your AP to the POE port on the power injector with an Ethernet Cable.
4. Plug the provided power adapter into the DC jack on the power injector, and the
other end to a standard electrical wall socket.
5. Then you can configure the AP according to 2 Configuring the device.
Product information can be found on our official website: http://www.tp-link.com.
Appendix 1: With PoE Setup
Note
1. Passive PoE Injector supports a maximum cable length up to 30 meters
due to the environment.
2. For longer powered cable up to 100 meters, please choose TP-LINK's 48V
PoE adapters: TL-POE200 or TL-POE150S & TL-POE10R.
To Next Page
Loading...
