5
Chapter 1
Get to Know About Your Powerline Extender
1. 3. 2. Physical Interface
Wi-Fi Button
Press and hold the button for 1 second to copy wireless settings from the main router
to the extender. Go to Wi-Fi Clone for more information.
Press and hold the button for at least 5 seconds to turn the wireless function on or off.
The wireless function is on by default. You can turn them off at night and then on in the
morning by pressing the Wi-Fi button.
LED Button
Press and hold the LED button for 1 second to turn all LEDs on or off. All LEDs are on by
default. If you don’t feel like being bothered by the LED light at night, press and hold
the button for 1 second to turn all LEDs off. The next morning, just press and hold the
button again to turn them on.
Pair Button
Press and hold the button for 1 second to join a powerline network. Go to To Set Up a
New Secure Wireless Network for more information.
Press and hold the button for about 8 seconds to leave the existing powerline network.
Power Plug
The extender has a Power Plug which can connect to any (100V-240V~, 50/60Hz) power
socket.
LED Button
Ethernet Port
Reset Button
Pair Button
Wi-Fi Button
Power Plug
To Next Page
Loading...
